Installation and Maintenance

For optimum results the surface must be clean and free of all waxes. All stickers are designed to be installed on the outside of the vehicle.

For Vinyl Decals: Rub both sides of the decal hard with the edge of a credit card to make sure your decal is flat and has now bubbles before applying it to any surface. Place graphic on the desired surface and tape your decal to the surface with masking tape across the top, creating a hinge. Flip your graphic up and pull paper backing off, exposing the decal's adhesive. Hold graphic by the corners and flip back down so that adhesive is against surface. Use a driver license or credit card, and rub the graphic area with firm pressure from the top center out to the edges forcing all the air out. Any air bubbles should disappear. Remove the clear transfer tape by pulling straight back on a 180 degree angle, leaving the graphic on the surface. If the graphic comes of with the masking tape, firmly re-rub the graphic to the surface wait an hour before removing the masking tape. If any air bubbles are left you can poke them with a pin to pop them and then smooth them out by rubbing them down. Most tiny air bubbles will work themselves out over time through the sun's heat.

For Apparel: Your custom apparel is made to withstand normal washing and drying conditions. However, just for added life expectancy, we suggest that you wash your apparel inside out.